Contents
Boot zips are most often metal or nylon coil zips in size No. 5 with a closed end and an auto-lock slider that does not slide down while walking. The length is measured along the seam line, from the point where the zip starts above the sole to the top edge of the boot, leaving a small allowance for finishing. For low shoes and ankle boots No. 3 or No. 5 is usually enough, while heavy work boots take No. 8.
How to measure the length of a boot zip
The wrong length is the most common reason a zip does not lie flat or bends incorrectly. Measuring is simple if you follow a sequence:
- decide where the zip will start – usually a few centimetres above the sole, so that it does not bend in the area of the foot;
- measure along the seam line of the pattern, not in a straight line – on a curved boot the difference is significant;
- subtract the allowance for the top edge and the finishing of the edge;
- round to a standard length or order the exact length for the run;
- for a run with different shoe sizes, check the length on at least the smallest and the largest size.
The zip length is usually given from the top of the slider to the bottom end of the chain. State this in the order to avoid any mismatch.
Which zip size for boots and shoes
| Product | Size | Zip type |
|---|---|---|
| Low shoes, decorative zip | No. 3 | metal or nylon coil |
| Ankle boots and women's boots | No. 3 – No. 5 | metal or nylon coil |
| Knee-high boots | No. 5 | metal or nylon coil |
| Children's shoes | No. 3 – No. 5 | nylon coil, lighter |
| Work and heavy boots | No. 5 – No. 8 | metal or moulded-tooth |
The table is a guide. The final choice depends on the thickness of the leather, the curve of the pattern and the look of the model.
Metal or nylon coil zip for a boot
Metal zip
Metal zips are the classic choice for leather boots. They give a distinctive look, match the other metal accessories of the shoe and stand up well to friction. They come in finishes such as gold, antique brass, black and nickel-look (nickel free). On strongly curved patterns, check that the zip bends smoothly.
Nylon coil zip
A nylon coil zip is lighter and more flexible and follows the curve of the ankle. It suits ankle boots, textile boots, children's shoes and models where the zip sits on the inside and is not visible. The tape can be in the colour of the leather.
Boot zip sliders: why locking matters
When walking, the boot flexes with every step and the zip is under constant tension. A slider without a lock gradually slides down and the boot opens. That is why boots use:
- auto-lock slider – it locks as soon as you release the pull;
- pin-lock slider – a more secure lock for heavy models;
- pull with a leather or textile loop – easier pulling and a better look;
- zip puller with logo – a detail that shows the brand.
Reinforcing the zip in a shoe
The zip area is among the most stressed parts of a shoe. These are the solutions shoe manufacturers use most often:
- gusset (flap) under the zip – protects the sock and foot from friction and keeps out the cold;
- elastic gusset – on close-fitting boots it takes part of the tension;
- reinforced bottom end – a leather cap or an extra seam below the bottom stop;
- gluing and stitching – the tape is glued to the leather and then stitched so the parts do not shift;
- suitable thread – strong polyamide or polyester thread that matches the leather.
Another important detail is the top end: if the zip reaches the very edge, the slider can catch on the edge binding. That is why a few millimetres of free space are left.
Placement of the zip on a boot
Where the zip goes affects both comfort and the look of the model:
- on the inside – most common on women's and men's boots; the zip is discreet and easy to reach;
- on the outside, as a decorative element – on biker and fashion models, where a metal zip with large teeth is part of the design;
- at the back along the heel – on some tall boots and ankle boots; the tension here is high and reinforcement is essential;
- double – on both sides – on very narrow boots or on models designed for easier wear.
With a decorative zip on the outside, think about the slider pull too: it is always visible, so it is a good place for a logo or a shape linked to the brand. With a zip on the inside, the pull is better small and smooth so that it does not catch on the other leg while walking.
YKK zips for shoes
In the collection YKK zips for bags and shoes you will find original YKK metal and nylon coil zips suitable for boots and shoes. YKK is a third-party brand that Polkom offers. Some special series are not recommended for curved shoe openings, so if in doubt, ask for advice and a sample.
Common mistakes with boot zips
- measuring in a straight line instead of along the seam;
- a slider without a lock on a tall boot;
- too large a zip size on a fine women's model;
- no gusset under the zip;
- choosing the tape colour without a sample of the leather.
The surest protection against these mistakes is a trial pair: make a boot with the chosen zip, put it on and take it off many times and check that the slider stays in place while walking. Only then approve the lengths for all sizes in the run.
Zips and shoe accessories from Polkom
Polkom is a manufacturer of accessories for fashion, footwear and bags based in Sofia, with over 30 years of experience. Besides zips we also offer other shoe accessories – buckles, eyelets and metal elements with logo. We offer an OEKO-TEX® certificate for all products. Minimum quantities depend on the article. Send the shoe model and the lengths via the contact page and we will prepare samples for you.
Share this article












