Stranded Cotton Embroidery Floss: Hand Embroidery and Cross Stitch

Polkom · 4 min read
Stranded Cotton Embroidery Floss: Hand Embroidery and Cross Stitch

Stranded cotton embroidery floss (mouliné) is a mercerised cotton thread made of six fine strands loosely twisted together, which are separated as needed. It is used for hand embroidery – cross stitch on Aida fabric, satin stitch, outlines and lettering. On standard 14 count Aida you stitch with two strands of floss, and on coarser or finer Aida the number of strands is increased or reduced.

What stranded cotton floss is

The word mouliné comes from French and means “twisted”. Stranded floss is a cotton thread that has been mercerised: treated in a sodium hydroxide solution, after which the cotton becomes smoother, stronger and acquires a soft silky sheen. The colours of mercerised cotton are richer and more durable than those of ordinary cotton.

The key feature is that the floss is not used at its full thickness. The six strands are separated one by one and recombined in the desired number. This way the same thread gives you both a fine outline with one strand and a dense fill with three or four.

Embroidery floss for cross stitch: how many strands

The number of strands depends on the count of the Aida – how many squares there are per inch (2.54 cm). The aim is for the cross to cover the square without being too thick.

Aida (count)Squares per 10 cmStrands for cross stitchStrands for outlineTapestry needle
11about 4331–2No. 22
14about 5521No. 24
16about 6321No. 24–26
18about 711–21No. 26
Linen 28 (over 2 threads)about 55 crosses21No. 26–28

Tapestry needles have a blunt tip and a large eye. The blunt tip passes between the threads of the Aida without splitting them, and the large eye protects the floss from fraying.

How to separate stranded floss correctly

  1. Cut a length of about 40–50 cm. A longer thread twists, frays and loses its sheen as it passes repeatedly through the fabric.
  2. Hold one end and gently open up the strands.
  3. Slowly pull one strand upwards while holding the rest. They will bunch up but then straighten by themselves.
  4. Repeat for the required number of strands and put them back together, evening out the ends.
  5. Do not pull two strands at once – that way they twist and tangle.

Separating one strand at a time and recombining them (“stripping”) gives denser and more even coverage, because the strands lie parallel rather than twisted.

Other threads for hand embroidery

  • Perle cotton – a non-divisible, clearly twisted cotton thread with relief. Suitable for Hardanger, decorative stitches and outlines.
  • Matte cotton thread (coton à broder) – fine, non-divisible, with a matte look. Used for whitework and monograms.
  • Silk threads – for the finest details and transitions, in restoration and classic embroidery.
  • Wool threads – for tapestries and decorative panels, quick filling.
  • Metallic threads for hand embroidery – accents, shorter lengths and a larger needle.

Tips for clean hand embroidery with stranded floss

  • All top legs of the crosses in one direction. Otherwise the surface looks uneven in the light.
  • No knots on the back. Secure the thread under a few stitches on the reverse – knots show as bumps and can come undone in the wash.
  • Use a hoop or frame. Taut Aida gives even stitches.
  • Keep the colour numbers. If a colour runs out in the middle of the project, you will be able to reorder it without a difference in shade.
  • Wash the finished embroidery gently. Lukewarm water, mild detergent, no rubbing; iron from the reverse on a soft towel so as not to flatten the stitches.

How much floss you need for a project

Thread consumption depends on several factors: the Aida count, the number of strands, the area of each colour and the technique (full cross stitch, half stitch, outline). Most ready-made charts give the number of skeins for each colour – this is the most reliable guide. If you are making your own chart, count the crosses of each colour and stitch a test square to see how much thread goes into a given area. Buy with a small reserve and, if possible, from one dye lot: shades between different lots can differ slightly, and the difference is clearly visible in a large solid area.

Stranded floss for Bulgarian folk embroidery

Traditional Bulgarian folk embroidery (shevitsa) is most often stitched with red, black and navy stranded floss, sometimes with wool or silk thread. For counted-thread embroidery on linen, two or three strands of floss are used depending on the density of the fabric. Saturated red tones should be pre-washed or tested for colour bleeding before being stitched onto white linen.

Stranded floss or machine embroidery for a serial product

Hand embroidery with stranded floss is suitable for one-off items, souvenirs, traditional folk embroidery and limited runs. When you need to embroider the same logo on hundreds of garments, the solution is machine embroidery with rayon or polyester threads in weight 40. They are designed for high speeds, are stable in the wash and allow every piece to be repeated identically. See the embroidery threads catalogue for the machine options.

If you hand-embroider on cotton or linen, you will need suitable cotton threads for the construction seams. Hand-embroidered items are often marked with a small woven label with the name of the atelier.

Wholesale embroidery threads from Polkom

Polkom is a Bulgarian manufacturer of accessories for fashion, furniture, footwear and bags with over 30 years of experience. We work mainly with ateliers, brands and manufacturers and deliver across the EU. If you are looking for wholesale threads for hand or machine embroidery, send an inquiry with the type, colours and approximate quantities – we will check availability and offer you a quote and samples. Write to us via Contact.

Share this article

Direct from the manufacturer

Related products

Direct from the manufacturer – samples and production to your design, colour and logo

Request a quote Request a sample
FAQ

Frequently asked questions

How many strands of floss are used for cross stitch?
For the most common 14 count Aida, two strands of floss are used for the crosses and one strand for the outlines. On coarser 11 count Aida you stitch with three strands, and on fine 18 count with one or two. The aim is for the cross to cover the square well without distorting the threads of the Aida.
Does stranded floss bleed colour in the wash?
Quality mercerised floss has good colour fastness, but saturated reds, burgundy and navy shades sometimes bleed in the first wash. Wash the embroidery in lukewarm water with a mild detergent, without rubbing and without soaking. If in doubt, test a small piece before washing the whole item.
How does stranded floss differ from perle cotton?
Stranded floss consists of six fine strands that are separated and used in different numbers. Perle cotton is a single non-divisible, more tightly twisted thread with pronounced relief and sheen. Stranded floss is more versatile for cross stitch and satin stitch, while perle cotton is preferred for decorative stitches, Hardanger and outlines.
Custom offer
Looking for a specific model, colour or size?

Send us an inquiry with a description or photo – you will receive an offer, samples and a production lead time.