YKK Invisible Zip – Chain Sizes and Lengths for Dresses, Skirts and Trousers

Polkom · 5 min read
YKK Invisible Zip – Chain Sizes and Lengths for Dresses, Skirts and Trousers

With a YKK invisible zip, the sizes are defined by two parameters – coil size and length. For clothing a fine No. 3 coil is most often used, and the length is chosen a few centimetres longer than the opening: about 18–23 cm for skirts and trousers, 35–60 cm for dresses, and up to the full length of the back on evening styles. Finer and larger sizes are used for very light or heavier fabrics.

YKK invisible zip sizes: what the number means

The number of an invisible zip, as with other zips, describes the width of the closed coil in millimetres, approximately. Invisible zips are fine by definition, because the coil has to hide in the seam. So the range is narrow:

SizeCharacteristicTypical use
Finer than No. 3Very thin coil and tapeChiffon, silk, light blouses, lingerie
No. 3The standard sizeDresses, skirts, trousers, most garments
Larger (e.g. No. 5)Stronger coilDense fabrics, coats, home textiles

The availability of finer and larger sizes in the YKK Conceal line depends on the model and colour and is confirmed on inquiry. For mass-market clothing No. 3 covers the vast majority of needs.

YKK invisible zip lengths by product

ProductPositionApproximate length
SkirtSide or back seam18–23 cm
Women's trousersSide seam18–23 cm
BlouseSide or back seam20–35 cm
Dress to the waistBack seam35–45 cm
Dress with the zip below the waistBack seam50–60 cm
Evening and wedding dressBack seam, to the hip55–75 cm and more
Cushion coverEdgeAccording to the size of the cover

The values are a guide. The real length depends on the cut, the size of the garment and whether the zip must allow dressing over the head or over the legs.

How the length of an invisible zip is measured

The length of an invisible zip is measured from the top stop to the bottom stop, excluding the tape above and below them. It is important to know that after sewing in, the effective opening is slightly shorter than the zip length, because the slider and the bottom stop take up space and the seam below the zip starts slightly above the bottom end. So the rule is:

  • zip length = opening length + 2–3 cm.

The extra centimetres allow the slider to go below the end of the opening and the zip to open fully. This is especially important for tight dresses that are hard to put on.

How to calculate the opening

  1. Determine the widest point the body has to pass through. For a skirt this is the hip, for a dress the shoulders or the hip.
  2. Measure from the top edge of the garment to that point along the seam line.
  3. Add ease for comfort – a few centimetres for tight cuts.
  4. Add 2–3 cm for the slider and you have the zip length.
  5. Check on a sample – put the prototype on and see whether dressing is comfortable.

Lengths across a size range

In series production each garment size theoretically needs a different zip length. In practice brands group sizes – for example one length for the small sizes and one for the large. This keeps stock simpler, and a difference of a centimetre or two is absorbed by the allowance. Calculate the groups from the patterns and record them in the tech pack.

Standard or non-standard length

Standard lengths are easier to order. If the product requires an exact length that is not standard, you have two options: order a longer zip and shorten it in the workshop, or order a zip in a specific length on request. The second option is more convenient for large runs, but the possibility and lead times are clarified on inquiry.

Shortening a longer zip in the workshop

When the required length is not standard, many workshops order the next longer standard length and shorten it when sewing in. With an invisible zip this is done at the bottom: the required length is measured, a new stop is made at that point with several dense stitches by hand or machine through both halves of the coil, and the excess is cut off about 2 cm below it. It is important that the slider does not pass below the new stop. The method is convenient for small runs and samples, but with large quantities ordering the exact length saves an operation and reduces the risk of errors.

Coil size and fabric

Choosing the size is not only a question of strength. A coil that is too large in a thin fabric is heavy, distorts the seam and shows as a stripe under the fabric. A coil that is too fine in a dense wool fabric or in tight stretch denim trousers may not withstand the tension and may split. So with unusual fabrics it is best to test a sample – sew in the zip and check its behaviour when stretched, when sitting and after washing.

Colour as the third parameter

Size and length are only part of the specification. With an invisible zip the tape colour is just as important, because the tape lies right next to the face side of the seam. Choose a number from the YKK colour card to match the fabric.

Common mistakes

  • A zip the length of the opening – the slider cannot go down far enough and the zip does not open fully.
  • A zip that is too short on a tight dress – the garment is hard to put on and the seam tears at the bottom of the zip.
  • The same length for all sizes – dressing is uncomfortable in the large sizes.
  • A larger size on a fine fabric – the zip is heavy and shows as a stripe.

Ordering YKK invisible zips

Polkom is a Bulgarian manufacturer of garment accessories. We also offer original YKK Conceal zips – YKK is a third-party brand that we do not manufacture. Browse YKK invisible zips and the other YKK lines. Send us the product, the lengths by size, the colours and approximate quantities via our contact page and you will receive a quote, with lead times on request.

Share this article

Direct from the manufacturer

Related products

Direct from the manufacturer – samples and production to your design, colour and logo

Request a quote Request a sample
Gallery

From our production

FAQ

Frequently asked questions

How long an invisible zip do I need for a dress?
It depends on the cut. For a dress with a zip to the waist, an invisible zip of about 35–45 cm is usually enough, while for a dress that is put on over the hips or an evening dress, 55 cm and more. Calculate the opening from the pattern and add 2–3 cm so that the slider can go below the end of the opening.
What size invisible zip is suitable for a skirt?
Most skirts use a No. 3 YKK invisible zip about 18–23 cm long in the side or back seam. With very light fabrics such as chiffon, a finer option can be chosen if available. The length depends on how far the skirt needs to open to pass over the hips.
Can I order a YKK invisible zip in a non-standard length?
With many models this is possible, especially for larger series quantities. The availability of a specific length in a specific colour and the lead times are clarified on inquiry. An alternative is to order a longer standard zip and shorten it in the workshop. State the exact lengths in your inquiry.
Custom offer
Looking for a specific model, colour or size?

Send us an inquiry with a description or photo – you will receive an offer, samples and a production lead time.